ExtremeSwitching (EOS) - Page 20 - Extreme Networks

ExtremeSwitching (EOS)

Questions and discussions about EOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Inter vlan without configuration

Hi, We have a problem with our network.. the routing switch serie B5 enterasys is configured as below: ************************************************************************** #vlan set vlan create 30 set vlan create 31 set vlan create 40 set v...

Resolved! Creation of a Lag Summit against Cisco

I have a port-channel between a Cisco 4500 and a summit x450 with two interfaces. When monitoring them, I only see the traffic through one interface, it is not distributed by the second member.

CRC errors stack ports exos 16.2.5.4

Good afternoon. I am using a project stack of 4 extreme switches (2-x670 vim 4-40G4X module, 2-x460 v80 module). I am constantly seeing an increase in CRC errors on stack ports. Modules were replaced by me. Updated switch version to 16.2.5.4 patch1-2...

Resolved! A4H124 former stack ports not available

Hello,I have recently replaced a SecureStack A4H124 stack member: removed a 24 port unit and replaced with a 48 port one (both were A4H124-xxP).Now, ports 25 & 26 (which were the stack ports in the 24 port unit) are not available in the 48 port unit,...

Resolved! FAN Speed Control Behavior on an S-Series S8

Good morning,I have a question related to Fan Speed Control behavior on an S8-CHASSIS-POERunning “show system hardware” I got Fan1 Temp, Fan2 Temp, Ambient Temp and temperature for each installed slot.It’s not clear what sensors I have to take accoun...

Top Kudoed Authors

User

Count

4

2

2

2

2

GTM-P2G8KFN