How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-23-2018 09:53 PM
Hi community,
It is possible to configure Dynamic LAG's with LACP between Summit x690 and S4 S-Series?
What is the correct way to do it?
Regards,
It is possible to configure Dynamic LAG's with LACP between Summit x690 and S4 S-Series?
What is the correct way to do it?
Regards,
3 REPLIES 3
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-29-2018 12:00 AM
Hi community,
Thanks for your help.
When I have the opportunity to try, I tell them what happened.
Regards,
Cristian
Thanks for your help.
When I have the opportunity to try, I tell them what happened.
Regards,
Cristian
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-25-2018 01:31 AM
Summit enable sharing 25 group 25-26 lacp 25 is the lead port To check status show port sharing Example:
code:
* X150-24p.41 # show port sharing
Load Sharing Monitor
Config Current Agg Ld Share Ld Share Agg Link Link Up
Master Master Control Algorithm Group Mbr State Transitions
==============================================================================
25 LACP L2 25 - R 0
L2 26 - R 0
==============================================================================
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-24-2018 12:34 PM
Hi Cristian,
Is is possible. In EXOS you don't care about keys, that's the difference:
enable sharing X port X-Y lacpWhere X is 'master port' (typically the first port of your lag, when you add LAG to a VLAN you just add X to that VLAN).
I would then do 'show lacp lag X' to see what partner admin key should be set on S-Series aggregation if you want to specify it.
'Show sharing' shows you if your aggregation is fine.
Hope that helps,
Tomasz
Is is possible. In EXOS you don't care about keys, that's the difference:
enable sharing X port X-Y lacpWhere X is 'master port' (typically the first port of your lag, when you add LAG to a VLAN you just add X to that VLAN).
I would then do 'show lacp lag X' to see what partner admin key should be set on S-Series aggregation if you want to specify it.
'Show sharing' shows you if your aggregation is fine.
Hope that helps,
Tomasz
