cancel
Showing results for 
Search instead for 
Did you mean: 

How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

How to Configure Dynamic LAGs with LACP on Summit x690 vs S-Series? Is this possible to do?

Cristian_Gonzal
New Contributor
Hi community,

It is possible to configure Dynamic LAG's with LACP between Summit x690 and S4 S-Series?

What is the correct way to do it?

Regards,
3 REPLIES 3

Cristian_Gonzal
New Contributor
Hi community,

Thanks for your help.

When I have the opportunity to try, I tell them what happened.

Regards,

Cristian

Jason_Parker
Contributor
Summit enable sharing 25 group 25-26 lacp 25 is the lead port To check status show port sharing Example:

code:
* X150-24p.41 # show port sharing
Load Sharing Monitor
Config Current Agg Ld Share Ld Share Agg Link Link Up
Master Master Control Algorithm Group Mbr State Transitions
==============================================================================
25 LACP L2 25 - R 0
L2 26 - R 0
==============================================================================

Tomasz
Valued Contributor II
Hi Cristian,

Is is possible. In EXOS you don't care about keys, that's the difference:
enable sharing X port X-Y lacpWhere X is 'master port' (typically the first port of your lag, when you add LAG to a VLAN you just add X to that VLAN).
I would then do 'show lacp lag X' to see what partner admin key should be set on S-Series aggregation if you want to specify it.
'Show sharing' shows you if your aggregation is fine.

Hope that helps,
Tomasz
GTM-P2G8KFN