10GBASE-LR/LW XFP problem

[Alexandr_P]

Hi, colleagues!

Have esome strange issue:
X460-48x
XGM3s-2xf
install 10GBASE-LR/LW XFP modules, connect them with optic patch and ports not up.
Try with other XGM3S-2xf, try with other transceivers, with other optic patchcord - nothing help.
Some outputs:
#deb hal sh op
Port 49Media Type XFP_LR
XFP Vendor: OEM
XFP Part Number: XFP-10G-LR
XFP Serial Number: S1106013011
XFP Revision: A
Date Code: 110819
Transceiver Type: XFP
Connector: LC
10GE Compliance: 10GBASE-LR/LW
XFP Supported: no
# sh ports 49-50 configuration no-refreshPort Configuration
Port Virtual Port Link Auto Speed Duplex Flow Load Media
router State State Neg Cfg Actual Cfg Actual Cntrl Master Pri Red
================================================================================
49 VR-Default E R OFF 10000 FULL !XFP_LR
50 VR-Default E R OFF 10000 FULL !XFP_LR

Any thoughts?

Thank you!

[Patrick_Voss]

10g optics should not require licensing. However, this does not mean that all optics will work. Is this an Extreme optic? If not can you see if an Extreme optic works (If you have one lying around). Also, did the logs have anything interesting to say when you plug in these optics?

[Alexandr_P]

The ! mean - that this is not original transceiver that have to work normally in 1/10G ports.
In 40/100G ports this is licensing.

Thank you!

[Patrick_Voss]

The ! means something in the configuration output. Can you check the logs and provide that full output?