Aggregation L3_L4 lacp Not working

[MANOJ_SHARMA]

Aggrigation L3_L4 lacp Not working when we confgure aggrigation . Load sharing is not happening seams some algo issue please suggest

When we add 3 ports in aggregation traffic on master ports not happening

[Drew_C]

Hi Manoj,
Have the suggestions here helped to answer your questions?

[PARTHIBAN_CHINN]

Hello Manoj,

What is the juniper switch you are using.

there is difference in lag algorithm in juniper and extreme.

You fine tune in extreme switches with the below command:
configure sharing address-based custom [ipv4 [source-only | destination-only |source-and-destination] | hash-algorithm [xor | crc-16 | crc-32 [lower | upper]]]

Are you facing issues with incoming or outgoing traffic in the lacp agg?
Means from juniper or traffic towards juniper?

Regards,
Parthiban Chinnaya

[Prashanth_KG]

Hi Manoj,

Looking at this output,

* SW02.54 # show sharing Load Sharing Monitor
Config Current Agg Ld Share Ld Share Agg Link Link Up
Master Master Control Algorithm Group Mbr State Transitions
==============================================================================

10:6 LACP L3_L4 10:6 - A 2
L3_L4 10:27 - A 4

it seems like the ports are not part of the aggregation group itself.

Please check if the LACP PDUs are sent and received on the ports.

collect the following outputs:

show lacp counters.

This article would help you in troubleshooting.

https://gtacknowledge.extremenetworks.com/articles/How_To/How-to-verify-if-the-LACP-PDUs-are-receive...

Let us know if we can help further!

[MANOJ_SHARMA]

ExtremeXOS version 12.5.5.4 we are using