Hello,unfortunately I had to realize that the switch logs are empty after a power failure. Or the last entries are several weeks old (Power failure was on 17.01.25 the last log entries are from 06.12.24. I know for sure that there were log entries be...
Added a new exos switch to one of my sites, remoting into to do initial configuration, I seem to be getting stuck on the IQagent staying in a disabled state, I already specified which virtual router to use to connect to XIQ, is there a command I need...
Hello!I have to configure LLDP-MED in a 4220 and the command is not allowed by the CLI:Enable lldp port allconfigure lldp port all advertise vendor-specific med capabilitiesconfigure lldp port all advertise vendor-specific med power-via-mdiconfigure ...
Suggest a latest firmware for Extreme 3626GTS
Only one cisco AIR-CAP2702I-K-K9 is connected to port 23Currently, when log and show inline-power info port 23, the state goes back and forth to disable/deliveryThe problem is 1. Currently, users are using it without any problems2. port 1-22 까지 disab...
