ExtremeSwitching (EXOS/Switch Engine) - Page 2 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Resolved! Clarification on ring topology with LAG setup

We have 3 sites that deploy 2 x460 at each site in a stack. The sites are connected to each other via a shared interface of two ports on each siteSite A Port 25, Port 26 --> Site B Port 27, Port 28Site B Port 25, Port 26 --> Site C Port 27, Port 28Si...

Resolved! Is it possible to mix stacking method when I stack 5520 with 5420 series switches?

Is it possible to mix stacking method when I stack 2 switches 5520 (without VIM-4X) and 2 switches 5420 series switches using U1 and U2 port , using QSFT+ to QSFP+ cable between 5520 (SummitStack-V160) and special cable which converts QSFP+ to SFP-DD...

Resolved! how to stack switch 5520 with VIM-4XE and 5420

hi, I'd like to know which is the best method to stack 2 switch 5520 24p fiber with VIM-4XE installed and 2 switch 5420 48p. Is it possible to stack using SFP+ module installed in VIM-4XE module, or I should use stacking port U1 and U2 with proper ca...

Resolved! Connected to ExtremeCloud IQ warning

I have brought several Extreme switches from a recycling center and I am setting them up for use on my home network. While I have reset them to the point I can log in to them I have noticed one of them, a X435-8P-4S, is showing the message "Warning:...

ERS MLT Conversion to EXOS

Hello,Our customer wants to change his " stack " of ERS4926 bound in MLT on a " core " of 8600 (SMLT) by universal switch 5320 in EXOS mode.Is there a document that describes how to convert the ERS4926’s MLT to a similar feature on EXOS with the inte...

Top Kudoed Authors

User

Count

28

26

20

20

17

GTM-P2G8KFN