ExtremeSwitching (EXOS/Switch Engine) - Page 385 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

I am using Black Diamond 8810 and installed new 48 port module in bay 4 and I am facing port up/down problem on this module.

Hello Community ! I am wandering, if the following setup is possible to work: 1. We have a set (let's say 5) of typical /24 subnets. 2. There are separate DHCP pools defined for each subnet on single MS DHCP server. 3. We have a router configured fo...

ERLP not working when using vlan default

I have a X440-G2-24P-10GE4 switch and configured two vlan's. VLAN-A and VLAN-B Firmware is 22.4.1.4 In VLAN-A there are the ports 1,2,3 and 4 and in VLAN-B ports 5,6,7 and 8. To make sure that there a no connetions made between VLAN-A and VLAN-B ...

copy firmware from primary to secondary

I update the firmware on my EXOS switch and after reboot I want to put that firmware on the primary partition. Is there a way to do that?

A little ACL help

I'm developing an ACL to allow guest use of certian resources on my network. In the end, the guest network will be its own subnet. So, I want to apply this ACL at the VLAN level. I've got the ACL working at the port level, but when I apply it to t...

ACL counters not showing

Hi, I have an ACL defined to manage general access between subnets across switches, and as part of that some rules have counters assigned to them. The problem I am having is that when I use the show access-list counter command, not all of my counte...

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN