How to disable auto completion commands in CLI
Is there a way to disable auto completion commands in XOS? for an e.g., show configuration instead of sh conf
Forum Posts
Extreme Summit Switches Upgrade Patch
Hi All, I am going to upgrade the Extreme Summit Switches x460 from 12.5.4.5 to 16.1.3.6. Is that any required path need to achieve first or can directly upgrade from 12.5 to 16.1 within one step? Thanks for your help. Best regards, Chia Hong
Firmware update kills SSL?
When we recently upgraded our X450 stack, we found the SSL module was not loaded on the backup configuration. Do we just install it the same way as the primary firmware, or will it bung the firmware?
Help to determine the most suitable STP type for my configuration
Hello, everybody! I have a network, where only Extremes exist. Access layer are 8 stacks spread through floors. Distribution layer is a stack of 2 X670. Core layer are two BD8806 connected with MLAG. There is also VRRP configured. There is one e...
Uplinks are shown as blocked in VLANs + EAPS configured XOS switch
This is newly configured switch which will be connected to the production network. Before it I have to be sure about one thing. I have set up below EAPS config and VLANs. And still uplinks 1:52 and 2:53 are not connected (other nodes of the EAPS ring...
