ExtremeSwitching (EXOS/Switch Engine) - Page 561 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Creating VLAN ACL on BD8806

trying to create VLAN acl on BD8806 and getting the below error; SKB-BD8806.38 # configure access-list PEM_LOOP ports 2:48 egress Error: Policy PEM_LOOP has syntax errors Line 3 : Attribute cvid is not supported in this platform. ACL is very simpl...

Updates for 8800 module

Hi everybody) can you please answer a question. I am not a regular user of these devices, but I need to know how to make latest update for them, I bought G48Tc 41517 Black Diamond 8800 48-Port on ebay, should I pay for any licenses for updates, or i...

BD8800 latest stable XOS

Can anyone point me in the direction of the latest stable BD8800 XOS version that you haven't had any issues with?

Extreme L3 switch doesn't send icmp redirect packet.

In the network there are a L3 Extreme Networks switch and a Cisco wan router. Both devices operate with OSPF. The pc has a default gateway, which is the L3 switch. When I connect to a device which is connected through the cisco router, I expect ...

MLAG versus Stack

I was going through the definitions of MLAG support on Extreme Switches (670, BD8000 & BDX8) and link aggregation on stacked switches (All summit) and wondering to understand the difference between these two. If I am proposing X460 in a place where c...

Top Kudoed Authors

User

Count

32

28

20

20

17

GTM-P2G8KFN