hi everybody, I have 4 Switch Extreme, two BlackDiamond 8801 in Datacenter1 and two Summit x460 in DataCenter 2. I need configure vrrp, but i not understand the best practices for the use VRID. this is a topology: Use the same or diferents VRID?...
configure ports [port_list|all] monitor vlan vlan_name {rx-only | tx-only} this command under 15.7.1.4 firmware function will fail ex: Current State: OPERATIONAL Image Selected: secondary Image Booted: secondary Primary ver: 15.7.1....
Hi all, I'm looking to migrate a configuration where we have 2 separate X670-48 (not X670-V) into a stack. We currently have a LAG of 40Gbps between the two switches which is routed What is the recommended setup, and what is the procedure for migr...
What's wrong? ExtremeXOS Advanced Edge License Features: PIM-SM-Edge (limited to max of 2 active interfaces) -------------------- configure pim add vlan "DownlinkUn" sparse enable pim * X450a-24t.26 # configure pim crp vlan DownlinkUn multicast Err...
I've been running into a lot of problems with poe devices that are class4 and require PoE+. I have VoIP phones and Wireless AP (802.11AC) that aren't getting the correct amount of power. I have lldp enabled on the port with the AP (enable lldp por...
