ExtremeSwitching (EXOS/Switch Engine) - Page 722 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

What product can meet the requirement

Swicht L2 1. Capacity: - Unicast >=48Gbps - Multicast >=2.4Gbps - Switching mode: Support ? (Store and forward, Cut through, Fragment free) - Mac table >=8k 2. Interface - >=16-24 electrical ports (Ethernet 100Mbps) - All...

when dhcp snooping entries removed ?

Hi ; I know that we can clear dhcp-bindings for a port manually. Are there any way to clear dhcp-bindings when an interface is down ? Is there any way to create a timer for that or am i have to wait for the dhcp lease time? Regards, Burak.

equivalent to "show ipfdb" command on xos

I am trying to figure out the layer 3 capacity of my x440 switch. Is there a "show ipfdb" command like there used to be in extremeware os?

XOS stacking commands not visible in "show config"

During the last weeks i configure several X440 and X670 stacks with XOS V15.6.2.x. After setting up the stack with the needed commands all works fine. Then i want to see these entered commands in the "show config" or "show config all" output - but th...

Perimeter Switch Recommendation: Which Model should I use?

Need to support: 10/100/1000BASE-T (RJ-45), SPF+ GBIC, out-of-band management port, GBP, VRRP and IP Tunneling. Got any suggestions?

Top Kudoed Authors

User

Count

33

29

21

20

17

GTM-P2G8KFN