cancel
Showing results forĀ 
Search instead forĀ 
Did you mean:Ā 

configuration of Multiple BGP links on a single port interface to seperate jisc location though same AS

configuration of Multiple BGP links on a single port interface to seperate jisc location though same AS

RodR
New Contributor

Hi

I have a requirement to change the current bgp Jisc ( janet connections ) from a single link and single neighbour, with all the policy entries to support this.

I now have a requirement to actuall add another vlan on the same interface to jisc , where the remote neighbour is at another location.

So the basic network configuration is very normal ..

What I do not understand is do I modify the existing policy files , for example

conf bgp neighbor 10.101.10.101 route-policy in BGP_IN_FROM_JANET

or do I need to create a  new policy for the  new link as it has a different neighbor  though the same AS number

The same discussion re bgp export ospf-internal1 xxx export_policy_from_ospf , do I need a rule per link ?

I look forward to your comments

1 REPLY 1

Gabriel_G
Extreme Employee
Hi Rod,

The 'configure bgp neighbor .... route-policy' commands apply per neighbor, not per link. They limit which routes are advertised to, or filtered from, the specified neighbor which does not happen on the link level.

For the 'enable bgp export' commands, those are global commands that apply to the BGP process in general, which would apply to all neighbors for that BGP process.

Hope that helps!
GTM-P2G8KFN