Initial setup on X440-g2-24p Can't ping between devices with static ip's on ports 2 and 3 (or any others)
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-17-2017 03:14 PM
Initial setup, Out of Box configuration... Using the default VLAN, I can't ping between two statically set ips on devices attached to ports 2 and 3. (or any other two ports)
I have:
configure vlan default add ports 1-28
configure vlan default ipaddress 192.168.10.15 255.255.255.0
enable ip forwarding vlan default
configure iproute add default 192.168.10.1
configure bootprelay add 192.168.10.14 vr VR-Default
enable bootprelay ipv4 vlan Default
The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch.
I have:
configure vlan default add ports 1-28
configure vlan default ipaddress 192.168.10.15 255.255.255.0
enable ip forwarding vlan default
configure iproute add default 192.168.10.1
configure bootprelay add 192.168.10.14 vr VR-Default
enable bootprelay ipv4 vlan Default
The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch.
13 REPLIES 13
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-18-2017 12:01 AM
Hi,
Add the script to reference FN412 from KCS.
https://gtacknowledge.extremenetworks.com/articles/Solution/FN412-EXOS-21-1-1-Patch-1-2-will-not-for...
Best regards,
Bin
Add the script to reference FN412 from KCS.
https://gtacknowledge.extremenetworks.com/articles/Solution/FN412-EXOS-21-1-1-Patch-1-2-will-not-for...
Best regards,
Bin
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-17-2017 03:31 PM
what are the IPs of devices connected to port 2 and 3?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-17-2017 03:31 PM
"The devices attached to ports 2 and 3 are windows 7 boxes with ips 10.16 and 10.17. Port 1 is the uplink to another switch."
The post was edited with this new information.
The post was edited with this new information.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-17-2017 03:30 PM
Hi Michael,
What version of EXOS is installed on your switch?
Out of the box, be aware of this condition: FN412 - EXOS 21.1.1 Patch 1-2 will not forward traffic with default configuration
The workaround listed there might be what it takes to get you going again.
What version of EXOS is installed on your switch?
Out of the box, be aware of this condition: FN412 - EXOS 21.1.1 Patch 1-2 will not forward traffic with default configuration
The workaround listed there might be what it takes to get you going again.