Not able to ping hosts in the VLAN

[Kalyan_Majumder]

The VLAN name is WCG_UPLINK-OAM

Here are the output

SRBHPP-EOAMSW-01.3 # show vlan WCG_UPLINK-OAMVLAN
Interface with name WCG_UPLINK-OAM created by user
Admin State: Enabled Tagging: 802.1Q Tag 116
Description: None
Virtual router: OM_CN
IPv4 Forwarding: Enabled
IPv4 MC Forwarding: Disabled
Primary IP: 172.18.175.138/29
IPv6 Forwarding: Disabled
IPv6 MC Forwarding: Disabled
IPv6: None
STPD: None
Protocol: Match all unfiltered protocols
Loopback: Disabled
NetLogin: Disabled
OpenFlow: Disabled
QosProfile: None configured
Egress Rate Limit Designated Port: None configured
Flood Rate Limit QosProfile: None configured
Ports: 1. (Number of active ports=1)
Untag: *6
Flags: (*) Active, (!) Disabled, (g) Load Sharing port
(b) Port blocked on the vlan, (m) Mac-Based port
(a) Egress traffic allowed for NetLogin
(u) Egress traffic unallowed for NetLogin
(t) Translate VLAN tag for Private-VLAN
(s) Private-VLAN System Port, (L) Loopback port
(e) Private-VLAN End Point Port
(x) VMAN Tag Translated port
(G) Multi-switch LAG Group port
(H) Dynamically added by MVRP
(U) Dynamically added uplink port
(V) Dynamically added by VM Tracking

SRBHPP-EOAMSW-01.4 # show iparp WCG_UPLINK-OAM
VR Destination Mac Age Static VLAN VID Port

Dynamic Entries : 0 Static Entries : 0
Pending Entries : 0
In Request : 104 In Response : 0
Out Request : 268 Out Response : 0
Failed Requests : 44
Proxy Answered : 0
Rx Error : 0 Dup IP Addr : 172.18.175.162
Rejected Count : Rejected IP :
Rejected Port : Rejected I/F :

Max ARP entries : 8192 Max ARP pending entries : 256
ARP address check: Enabled ARP refresh : Enabled
Timeout : 20 minutes ARP Sender-Mac Learning : Disabled
Locktime : 1000 milliseconds
Retransmit Time : 1000 milliseconds
Reachable Time : 900000 milliseconds (Auto)
Fast Convergence : Off

SRBHPP-EOAMSW-01.5 #

SRBHPP-EOAMSW-01.5 # show port 6 no-refresh Port Summary
Port Display VLAN Name Port Link Speed Duplex
# String (or # VLANs) State State Actual Actual
==================================================================
6 WCG_UPLINK-OAM E A 1000 FULL
==================================================================
Port State: D-Disabled, E-Enabled
Link State: A-Active, R-Ready, NP-Port not present, L-Loopback,
D-ELSM enabled but not up
d-Ethernet OAM enabled but not up
SRBHPP-EOAMSW-01.6 #

Not able to ping hosts in this VLAN.

Can anyone please post a possible solution.

[OscarK]

No, you can add it untagged.so a normal PC can be attached to the port.

[Kalyan_Majumder]

Yes , the destination host is in this range.Is it necessary to tag this VLAN as this is the only vlan present in this port ?

[OscarK]

This is a /29 subnet, so it starts at 172.18.175.137 and ends at 172.18.175.143. Is the host you are trying to ping in that range ?
Is your destination host able to use tagged frames (only port in this vlan is port 6 tagged).