OSPF Init stuck

[Julian_Eble]

Hello Community,

I'm in a odd journey trying to understand what's going on here.
There are two Extreme switchs connected by 2 10G ports running LACP.

The master port is UP and the member also is UP and everything is okay with LACP and OSPF between them.
But if the master port is disabled, the OSPF get stucked into Init state.

I tried to took off the port from the sharing and tried to solo running the ospf , but it didn't worked.

The stranger thing here is if that member port is in the sharing group it ran fine, without any loss.

What should I do? Any advices?

Thanks 

[Necheporenko__N]

Once an hello packet has been received, neighbor state will immediately transition from down to INIT state indicating that the hello packet was received but that the receiving router's ID was not the neighbor hello packet. In this state there is no bidi communication yet.

Once the router's ID is present in the hello packets, the neighbor state transitions to 2-WAY.
Check peers configuration accordingly.

Best Regards,
Nikolay

[Julian_Eble]

I'm receiving the hello from one side, but not for the other side.
There's a Bidi SFP+ connecting both switch and the ports are up.

[Alexander_Roman]

show me pls:

sh forw conf
sh conf | i to-cpu

[Alexander_Roman]

glad to help you.