Ports LEDs have to be lighting
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-30-2015 04:25 AM
Hi, all!
Have not so trivial question )))
We have some conference with Extreme stand.
I whant that Summit switches power on and all port LEDs have to be lighting.
Is there some commands or cycle LED tests to do this?
Thank you!
Have not so trivial question )))
We have some conference with Extreme stand.
I whant that Summit switches power on and all port LEDs have to be lighting.
Is there some commands or cycle LED tests to do this?
Thank you!
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-30-2015 04:48 AM
When run diag ext - testing ports and their flashing )))
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-30-2015 04:46 AM
These do not flash when disabling the ports.
You can connect all ports to eachother with lots of cables but that is not what you want probably.
I cannot think of any other method.
You can connect all ports to eachother with lots of cables but that is not what you want probably.
I cannot think of any other method.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-30-2015 04:42 AM
Summit X670, X460-G2 and C35 controller
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-30-2015 04:40 AM
What kind of switch ? Some switches make the port led flash when the port is disabled.
