ExtremeSwitching (EXOS/Switch Engine) - Page 495 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

IPv6 BGP network advertisement

Hi Experts Getting error while trying to advertise IPv6 routes in BGP peering. IPv4 works fine, but getting error in IPv6. The below network is preset in IPv6 routing table and shows as being directly connected. (vr Test) SwitchA # configure b...

MPLS Kernel error 16.1.3.6

VPLS VPN not working. After disabling see errorMPLS gport resolve failed for unit = 0 vpn = 0x70e3, port = 0xffffffff vp = 0x18000a0c, rv = -7 (Entry not found)08/30/2016 11:37:25.99extreme_mpls_del_vp_nh_xref: MPLS ECMP NH vp : 0xa0c l3intf = 0x83f ...

Is there a command to check the incoming DSCP value entering the switch?

Any command to check the incoming DSCP value entering the switch in ExtremeXOS version 16.1.3.6?

Tracking L2VPN state change

Hello everybody, I want to know a way to log the l2vpn peer state changes on my switch, is that possible? By using this MPLS.L2VPN.ChgPWState, am I going to see both vpls and vpws changes? Thanks!

Internal bandwidth of stacked switch?

Is the internal bandwidth of a switch limited when it is in a stacked configuration? e.g. 3x x670-48-g2 configured as a stack (v160), will the internal bandwidth of a switch then be limited to 320Gbps instead of 960Gbps. This is what a supplier su...

Top Kudoed Authors

User

Count

28

23

17

16

16

GTM-P2G8KFN