Removing OSPF routerid on VR-Default

[galimuna]

Hi,

I have a X460-G2 Switch which has 2 VRs configured on it and by mistake I configured a routerid on the VR-Default. Now, I am trying to remove the routerid from the VR-Default and leave only the VR-Production where it should be (this is the only VR that does OSPF on the Switch) and I couldn’t find anything until now. Does anyone had a similar issue? or does anyone have an idea how I could remove the routerid?

thanks in advance

[Miguel-Angel_RO]

galimuna,

If there is only L2 on the VR-Default, there is no impact.

You didn’t enabled ospf on the VR-Default.

You can set the routerid to another value (1.1.1.1 for example).

I didn’t checked the commands to remove the routerid.

It should be something like unconfigure, delete or disable

Mig

[galimuna]

This is the config of the other Switch:

#
# Module ospf configuration.
#
configure ospf vlan ISC priority 0
configure ospf vlan ISC_HELPER priority 0

#
# Module ospf configuration on virtual router VR-Production.
#
virtual-router VR-Production
configure ospf routerid 10.174.68.91
enable ospf
create ospf area 0.0.0.3

[galimuna]

Hi Miguel-Angel

the issue is this, I have on one Switch 2 VRs, one is VR-Default and VR-Production. On VR-Default is only L2 Switching but on VR-Production I have L3 and OSPF. By mistake I configured the routerid on VR-Default and VR-Production. I need to delete the routerid from the VR-Default configuration.

This Switch has an ISC with another switch which has only on VR-Production the routerid.

This is my configuration:

# Module ospf configuration.
#
configure ospf routerid 10.174.68.90
configure ospf vlan ISC priority 0
configure ospf vlan ISC_HELPER priority 0

#
# Module ospf configuration on virtual router VR-Production.
#
virtual-router VR-Production
configure ospf routerid 10.174.68.90
enable ospf
create ospf area 0.0.0.3

….

Thanks for the replay

[Miguel-Angel_RO]

galimuna,

It is no clear what you’ve done/ask.

Can you share the output of “show conf ospf”?

Mig