ExtremeSwitching (EXOS/Switch Engine) - Page 474 - Extreme Networks

ExtremeSwitching (EXOS/Switch Engine)

Questions and discussions about EXOS

Forum Posts

Sorted by:

Start a conversation

Switch Log shows "multicast entry not added"

Dear all I am using summit X440 stacked switch. when I checked the log I found the following logs. "03/08/2017 07:18:18.62 Slot-3: IPv4 multicast entry not added. Hardware L3 Table full. (Logged at most once per hour.)03/08/2017 07:18:14.45 Slot...

Hello. Please Help!! X460G2 is running with formware version 22.1.1.5.

My X460G2 was rebooted and upgraded to firmare version 22.1.1.5. This was intermittent about six hours. Then I rebooted again and its up. But can u help me?... What does this los´ mean? 03/06/2017 02:10:22.37 Slot-1: EPM Started 03/06/2017 02:10:22...

XOS Upgrade show * and . in upgrade progress

We are upgrading an X450A 48 port switches from XOS 15.3.1.4 to 15.3.5.2 There are three switches in a stack. During the upgrade the we see a some * instead of the . showing progress. Does anyone know what the * means? Normally we see lots of ......

Two IPs with different netmask on the same vlan

Can i add two ip in the same vlan? My Black Diamond (BD8810) have his management interface on my vlan50 with netmask 255.255.0.0 (/16) and i have one Cisco that have the same vlan50 with netmask 255.0.0.0 (/8) but for other network. I want to move ...

Disable Insecure Ciphers Extreme (x460)

Hi All, I was curious if there was a way to specify what protocols and ciphers are used in the XOS SSH module. Our internal vulnerability scans indicate the SSH module allows RC4 and other insecure ciphers.

Top Kudoed Authors

User

Count

28

26

19

18

17

GTM-P2G8KFN