I would like to have the entire configuration for a specific port > output in the same way you can view the entire configuration for a vlan with the pipe command.
as an example:
switch.name # show config | i V123
create vlan "V123-x_x" vr vr-xxx-xxx
configure vlan V123-x_x tag 123
configure vlan V123-x_x add ports 2:21, 4:7 tagged
configure vlan V123-x_x ipaddress 188.8.131.52 255.255.255.255
enable ipforwarding V123-x_x
enable bootprelay ipv4 V123-x_x
configure ospf add vlan V123-x_x area x.x.x.x passive
configure ospf vlan V123-x_x priority x
enable stpd S123-x_x auto-bind vlan V123-x_x
create vrrp vlan V123-x_x vrid x
configure vrrp vlan V123-x_x vrid x priority xxx
configure vrrp vlan V123-x_x vrid x preempt delay xx
configure vrrp vlan V123-x_x vrid 1 track-mode any
configure vrrp vlan V123-x_x vrid 1 accept-mode on
configure vrrp vlan V123-x_x vrid 1 add 184.108.40.206
enable vrrp vlan V123-x_x vrid x
!outputs the entire configuration for vlan 123
I would like to do the same thing for a specific port.
Some of the options to output the configuration for a port are:
sh port 1 information detail
show config | i 1 > where 1 is a port #. but 1 doesn't work because there are a lot of other instances where the # 1 is used in a configuration string.
you could do:
show config | i 45 > and the output is fine. but it won't work with the lower port #'s.
What i want output is all of the config and create commands that are applied to the port in question.
Ideally it would like it look something like this:
switch.name # show config | i Port 1 > but you can't do this because you cannot have a space between the word Port and 1. I have tried "Port 1" 'Port 1' Port-1 Port*1 and a few others. But none seem to work.
So... is there a way to have just the configuration commands output for a specific port doing something like this:
switch.name # show config | i Port 1
switch.name # show port config | i config
For some context, it would be the same thing in Cisco IOS when doing this:
switch#sh run int gi1/1
!outputs the configuration for int gi1/1
Any output (pun intended) would be Appreciated 🙂