Summit x450a after reset to factory default does not keep configuration

[Haim_Levi]

Hi,







I have 2 summit x450a that after they were reset to factory default the switches started up with blank configuration as can be seen from the attached sample below and except for vlan that I was able to configure every other configuration, although seem to be accepted does not show in the console when executing "show configuration" the sections keep showing empty / blank as the attached sample



Does the switch have any "en" mode as cisco?



How Can I configure the switch?







Thanks















#



# Module bfd configuration.



#







#



# Module cfgmgr configuration.



#







#



# Module dosprotect configuration.



#







#



# Module dot1ag configuration.



#







#



# Module eaps configuration.



#







#



# Module edp configuration.



#

[Haim_Levi]

* X450a-24t.19 #
* X450a-24t.19 # show switch

SysName: X450a-24t
SysLocation:
SysContact: [email protected], +1 888 257 3000
System MAC: 00:04:96:27:C0:2E
System Type: X450a-24t

SysHealth check: Enabled (Normal)
Recovery Mode: All
System Watchdog: Enabled

Current Time: Mon Sep 22 10:11:26 2014
Timezone: [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC.
Boot Time: Mon Sep 22 08:26:41 2014
Boot Count: 21
Next Reboot: None scheduled
System UpTime: 1 hour 44 minutes 45 seconds

Current State: OPERATIONAL
Image Selected: primary
Image Booted: primary
Primary ver: 12.4.1.7
Secondary ver: 11.5.2.10

Config Selected: secondary.cfg
Config Booted: secondary.cfg

secondary.cfg Created by ExtremeXOS version 12.4.1.7
144515 bytes saved on Mon Sep 22 08:21:32 2014
* X450a-24t.20 #

[rbrt]

Can you paste the output of "show switch" here?

[Haim_Levi]

Thanks for the reply Robert, 2 additional ones did configure and save with no problem, these 2 do not show anything after configuration, sections keep showing empty

[rbrt]

There is no enable mode like Cisco has it. Instead, with ExtremeXOS you have admin and user accounts. As the switches were reset to factory default I suspect that you log in with user "admin" and without a password. With this user, configure whatever you like, save the configuration (the command is "save") and you are done.

However, everything you configure should show up in the configuration. This is in real-time, at least with XOS 15.3 and upwards. I do not know older releases and how they behave though.