x670-x440 Vrrp change master to backup, not routing
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-08-2018 10:19 AM
We have 2 stacks both stacks are 1 x460 and 1x440 and an ISC connecting. When we try to fail over to the backup, the backup takes over as master but routing of the layer 3 vlans is not happening. FW Version we are using is 21.1.5.2
Any help or ideas much will be appreciated.
.
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-08-2018 10:57 AM
ipforwarding enabled on the backup?
Johan Hendrik
System Architect
Audax
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-08-2018 10:57 AM
ok in the config on the backup x460 the ipforwarding is not enabled, But your saying it needs to be there ok. I am new to extreme but we can try it to see it works.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-08-2018 10:57 AM
It should be enabled in the config, even though it should not be forwarding was the other stack is vrrp master
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-08-2018 10:57 AM
ipforwarding on the backup takes place after it takes over as the master or no?
