Adding on X670G2 to an existing OSPF network

[JohanHendrikx]

The OSPF network is a X460-24t and two cisco routers. all configured in the same area.

The fimrware of the X460 and the X670 is 16.1.2.14.

But for some reason the X670 is not learning or distribute any route.

How can I troubleshoot this ?

[Bill_Stritzinge]

Johan,

Please check the configuration for OSPF "hello timers" and make sure they are the same for both the Extreme and Cisco. If they are different you will not have any communications.

Bill

[JohanHendrikx]

The timers should be oke , because the x460 receive all the routes

[Henrique]

Hi Johan, could you please share the output for "show ospf interfaces" command?

Thanks

[OscarK]

To export all IP vlans with ospf use command:
enable ospf export direct cost 2 type ase-type-1

[JohanHendrikx]

GIDAT 144.2.144.249 /21 0.0.0.0 -rif--- 2/A ODR 4
GIDTP 10.2.120.254 /24 0.0.0.0 -rif--- 4/A DR 0
GITEST 10.2.128.254 /24 0.0.0.0 -rif--- 2/A DR 0
GIVOIP1 10.2.161.254 /24 0.0.0.0 -rif--- 4/A DR 0