Lacp lag L3 address

[Amir_A_N]

Hello everyone! I have an Extreme switch x620-16x. I need to configure lag port according to source OR destination IP address. So I have to configure as the following commands [configure sharing address-based ...] but the OS cann't recognize the [address-based]. My license level is Edge and my OS version is 21.1.1.4 patch1-5. Is there any solution?]

[M_Nees]

Hi Amir,

as a short advice - please install recent firmware 22.3.1.4-Patch1-4 on that switch - it makes more fun ....

Regards,
Matthias

[Narayanan__Kart]

Hi Amir,

It looks to be platform limitation on X620.

Please find the below article for more information:

https://gtacknowledge.extremenetworks.com/articles/Q_A/Custom-Algorithm-option-for-sharing-not-avail...

Regards,
Karthikeyan

[Bin]

Hi Amir,

Kindly reference your our config guide about "Customer Algorithms" on Load-sharing algorithms.

Custom hash algorithm is not supported on ExtremeSwitching X440G2 and X620 series switches.

http://documentation.extremenetworks.com/exos_22.3/EXOS_21_1/Slots_and_Ports/c_link-aggregation-stan...

Best regards,
Bin

[Amir_A_N]

So bad. Thanks