ExtremeSwitching (Other) - Page 70 - Extreme Networks

ExtremeSwitching (Other)

Questions and discussions about switching in general

Forum Posts

Sorted by:

Start a conversation

Removal of a SummitStack member

How do you clean up stacking config and port info after a stack member has been removed? After removing a stack member by logging into the master node - and running "unconfigure stacking" {node address or slot number} then "reboot" {node address or...

New "Initial Configuration and Setup" Guide for 200 Series

Are you new to the 200 Series switches? Need some help doing initial setup and configuration for the software? We've collected some of the most common configuration tasks into a how-to guide, ExtremeSwitching 200 Series: Initial Configuration and S...

2017-12-11: New GTAC Knowledge Articles December 03 - 09, 2017

Here are the new articles that were published December 03 - December 09, 2017 in GTAC Knowledge: Sunday, December 03, 2017: Wireless clients devices are preferring WS-AP3825 AP over WS-AP3610 Monday, December 04, 2017: How does your ExtremeWireless...

Routing Tip for Switch 220 Series

how to configure Routing Between VLAN's on a 220 Series Switch. I have a new 220 Series Switch and i have configured 2 VLans ( 100 + 200 ) Every VLAN is Routing enabled and has the IP . 192.168.100.1 /24 and 192.168.200.1 /24 The Internet Gateway...

What is effect of changing stacking protocol on production stack?

I have a single X670V-48t (master, slot1) stacked with a X460-48x (backup, slot2) using V80 module in x460 to the X670 QSFP+ ports and both slots are showing the stacking protocol as "Standard". I need to add a stack node (X670G2-48x-4q, slot3) and ...

Top Kudoed Authors

User

Count

28

4

4

3

3

GTM-P2G8KFN