Possible to stack x480-48t with a x620-16X?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-25-2017 11:15 AM
I have an x480 that I want to add multiple 10G ports to. Is it possible to stack this with a x620-16X?
If yes, what modules would I need to add-on/buy for both switches?
If yes, what modules would I need to add-on/buy for both switches?
8 REPLIES 8
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-25-2017 12:37 PM
How about stacking the x480 with a X650-24x? Could that work?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-25-2017 11:27 AM
Do I have any options of buying a switch with multiple 10G ports to stack with the x480?
I know the x480 has the 4x10G module but I want more than 4 ports.
I know the x480 has the 4x10G module but I want more than 4 ports.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-25-2017 11:25 AM
Hello Kaon,
It is not possible due to the minimum and maximum code supported for those switches. The x480 can only be upgraded to 16.2 and the minimum version allowed on the x620 is 21.1.
It is not possible due to the minimum and maximum code supported for those switches. The x480 can only be upgraded to 16.2 and the minimum version allowed on the x620 is 21.1.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎04-25-2017 11:23 AM
Bad luck here. You need the same firmware on both units. But X620 starts on 21.x and X480 stays at 16.x. You can still use MLAG and EAPS, but each device will have own IP address and config. Z.
Regards
Zdeněk Pala
