ExtremeSwitching (VSP/Fabric Engine) - Page 15 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

Resolved! Unable to priorize an external route into IS-IS redistribution

Hi everybody,I'm facing a problem setting up a lab. This is my goal:* I have a lab with 3 VOSS devices forming a SPB Fabric* 2 of them have each one a BGP IPv4 peering learning the external default route; they redistribute this route into IS-IS in a ...

Resolved! Extreme 5520 VLAN Management w/VOSS

Hello, my name is Mike and I am new to the extreme world and was wondering if someone could please shed some light on setting up a new extreme 5520-48w POE switch. I am trying to configure VLAN management through the fiber VIM module. Currently the s...

Resolved! Fabric Extend through wireless bridge but keep management IP addresses for bridge elements

Hi,We recently create L3 fabric extend logical interfaces to extend fabric through a wireless bridge following this article: How To: How to configure L3 Fabric Extend on VSP4K and VSP7/VSP8K. | Extreme Portal (site.com) Logical interfaces were esta...

Swapping fibres in VSP SMLT to EXOS LAG = SMLT port down

I have 2 VSPs, VSP1 and VSP2 that have SMLT fibre connections to EXOS switch stacks that use sharing.I built a new EXOS switch stack to replace an existing one, created a new SMLT and all that worked fine. I then disconnected both fibres from the exi...

Captured traffic inconsistently VLAN-tagged

Hi all,I set up traffic monitoring on VOSS and EXOS switches, but the network analysis guys are complaining that captured traffic is asymetrically tagged, and this messes up with their software.On the EXOS switch, traffic is captured on selected port...

Top Kudoed Authors

User

Count

34

18

18

18

7

GTM-P2G8KFN