ExtremeSwitching (VSP/Fabric Engine) - Page 92 - Extreme Networks

ExtremeSwitching (VSP/Fabric Engine)

Questions and discussions about VSP/Fabric Engine

Forum Posts

Sorted by:

Start a conversation

ACL migration from Nortel ERS-8800 to VSP

Hey Everyone, We are migrating from our ERS-8800's to new VSP switches and I seem to be having issues with the new ACL configuration. Previously it was set to: filter acl 50 create inPort act 4092 name "PolicyName" filter acl 50 ace 97 create name...

disconnected: protocol error: rcvd type 0 (2)

I'm trying to get config from the switch using oxidized, but my switch gives an error message: "disconnected: protocol error: rcvd type 0 (2)" I'm not sure what causes this error, my ERS switches does not have this problem. The log below is from a V...

[VSP-8404] ip prefix-list

Can someone explain the basics of how an ip prefix-list works? Looking to deny the 239.255.255.250 from entering into the spbm multicast routing table. From what I've read it appears to be an allow list, so I would need to allow all other addresses w...

Resolved! ISIS routing between VSP and Other router

Hi all, I am wondering if anyone here has experience with the following situation. I have 2 VSP switches setup as a vIST cluster. Towards each of these VSPs I have a Juniper router which is running ISIS. The routers are interconnected as well which ...

Resolved! avaya switch password reset

Hi community, I need help for resetting a avaya ERS8010 switch password. i need to preserve configurations as well. i have seen an option for snmp rw, but i dont have rw configured. is there any way i can reset without loosing the configuration?. or...

Top Kudoed Authors

User

Count

29

15

14

11

5

GTM-P2G8KFN