Mgmt CLIP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-30-2023 08:08 AM
We recently installed some VSP8600 in version 8.10.0.0, however we are not able to manage the SW via SNMP or SSH, the workaround of the "MGMT-CLIP" that we have used in 7400 does not work, any advice?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-31-2023 06:34 AM
I would confirm what code versions you working with. There was no v8.10 for the VSP8600. Right now its at 8.1.X.
But I think I know your issue.
The VSP8600 operates a different VOSS code stream than the other VSP/VOSS/FabricEngine switches. VSP4K, VSP7K, VSP8200/8400.
And the VSP8600 code does not have feature parity with the VOSS/FabricEngine code.
The VSP8600 does not support Segmented Management. The Segmented Management feature is only available in VOSS/FabricEngine 8.2 and above.
To manage your VSP8600 you only need to IP reachability to any IP interface in the GRT. So that would be any CLIP or In-band IP.
If you can ping an IP interface just make sure your boot flags didn't change.
conf t
Boot config Flag ? Then make sure all your ssh, snmp and https is turned on.