RADIUS
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 06:39 AM
Hi guys,
its my first attempt of creating RADIUS which is already installed on a windows server R2 standard edition.
I then configure this on a cisco switch, but no luck as to how its supposed to work and authenticate any ideas
its my first attempt of creating RADIUS which is already installed on a windows server R2 standard edition.
I then configure this on a cisco switch, but no luck as to how its supposed to work and authenticate any ideas
11 REPLIES 11
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 08:27 AM
I think the main issue is that you use a switch from Cisco instead of Extreme Networks.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 08:27 AM
haha yeah good one. but then again cisco it is
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 08:19 AM
you then need to setup your policy, dictionary, authenticator and shared secret definitions on NPS.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 08:19 AM
Thank you  I will test
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-14-2018 08:19 AM
Next make sure the shared secret is setup between NPS and the switch. You should then try to ssh/telnet into the switch. Then check the NPS Appplication log to determine if the request if making it to NPS and what NPS is doing with it.
