AP's with link problems
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 04:54 AM
In our dashboard I noticed that ther where AP's with link problems. However there are no problems. How can I clear this messages ?
Johan Hendrik
System Architect
Audax
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 05:35 AM
OK then it's normal if the APs are connected via a 100Mb ports.
I'm not aware of any way to clear that alarm.
I'm not aware of any way to clear that alarm.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 05:04 AM
Ap's are connected to a 100 Mb port. Autosensing is working
Johan Hendrik
System Architect
Audax
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 05:04 AM
firmware version is 10.31.03.001. AP's are connected to a 100 Mb port.
Johan Hendrik
System Architect
Audax
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎07-25-2017 05:04 AM
Hi Johan,
What is the firmware version on the controller? Please check the below KB article,
https://gtacknowledge.extremenetworks.com/articles/Solution/AP-s-are-listed-in-the-AP-s-with-uplink-...
Regards,
Nathiya M
What is the firmware version on the controller? Please check the below KB article,
https://gtacknowledge.extremenetworks.com/articles/Solution/AP-s-are-listed-in-the-AP-s-with-uplink-...
Regards,
Nathiya M
