I have an WS-AP3805i with flashing green leds
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 03:31 PM
I have an WS-AP3805i that had been working but now the radio leds and power led are alternating flashing green. So the radio leds flash green and then the power led flashes green.
6 REPLIES 6
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 05:14 PM
I reset the port on the switch and it's working now, thank you for the help, I'll have to watch this one and see if it keeps working
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 05:00 PM
...then if you can ping it, can you SSH to it?
Doug Hyde
Director, Technical Support / Extreme Networks
Director, Technical Support / Extreme Networks
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 04:50 PM
Check the GUI > Reports > APs > Active APs.
Is the AP listed or not = active tunnel to the controller.
If not - does the AP get an IP, could you ping it, could you ping it from the controller interface that is enabled for AP registration.
Is the AP listed or not = active tunnel to the controller.
If not - does the AP get an IP, could you ping it, could you ping it from the controller interface that is enabled for AP registration.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎08-07-2018 04:26 PM
No it's not working. In the controller console it's showing up as inactive. I'm now noticing that the power led is flashing orange if that makes a difference?
