mobility tunnel
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-09-2017 10:42 PM
I have two controllers WC-35 with version 10.31.01.0048, and C4110 with version 09.21.10.0005, and i would like configure mobility tunnel between tow controllers, the controller´s dont have HA, this is possible?
14 REPLIES 14
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-10-2017 06:05 PM
Hello Salvador,
you don't need HA!
Regards
Stephan
you don't need HA!
Regards
Stephan
Regards
Stephan
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-10-2017 06:05 PM
No, they don't need to be on the same VLAN/subnet.
Is a route configured on the controller so they could reach each other - you could try a ping from controller#1 to controller#2 to see whether routing works.
Is a route configured on the controller so they could reach each other - you could try a ping from controller#1 to controller#2 to see whether routing works.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-10-2017 06:05 PM
i tryed and the tunnel does not up, i have differents segment of network on interface of register 10.10.1.0/24 and 10.10.3.0/24. is necesary that the inferfaces have the same network segment?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-10-2017 03:18 PM
But is necessary create a HA?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
05-10-2017 04:57 AM
Yes
