ap7532 factory default ap is adopted

[Fernando_Garcia]

Hello there..i have this ap which i want to factory reset. I used the Ap discovery tool but when tries to reset fails and send a message that the ap is adopted. Im stuck because i dont have the controller that adopts this one...what other method i can use to factory reset this AP?

[Christoph_S]

Hello Fernando,

What firmware version is the AP running on?

Can you SSH into it and do you have the login credentials? If you are able to console or SSH into it then please follow these instructions to default the config: How to factory reset the config of a WiNG AP or controller from CLI

To reset an AP using the discovery tool, it should not have been up for more than 10 minutes. Reboot the AP and try again. You will need the serial number of the AP.

SSH into this AP if possible and run the following command to determine which AP is the controller should you need this information:
>en #show adoption status I hope this helps,

Regards

Chris

[RobertZ]

default password may be motorola

have you unplugged it from the network?

if you get in you can run the following commands :
delete startup-config
reload

[Fernando_Garcia]

I use that, Ap resets but remains the original configuration..dont know the password..tried admin-admin admin-Admin123 no luck

[RobertZ]

if you have a console cable, log in as u: reset p: FactoryDefault