Can I have 2 WLC on the same VLAN by different WLC model and without cluster
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-10-2019 04:15 PM
Can I have 2 WLC on the same VLAN ?
WLC1 for old model such as 650,6511,6521
WLC2 for New model 76xx and higher
Will they do any disturb to system ? Should I separate them to different VLAN ?
Please suggest
Thank for your advance .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎10-15-2019 03:59 PM
Hi all
Follow the pic
Vlan 10 for manage all devices WLC1,switch,server,pc etc...
WLC1(RFS6000)firmware 5.8.4 VLAN :10 Uplink to switch configured as trunk Native vlan 10
WLC2(NX5500)firmware 5.8.9 VLAN :11 Uplink to switch configured as trunk Native vlan 11 allow vlan10
Issue : I remove vlan 11 all switchs port that connect to WLC1 , But APs still adoption to WLC2
pleas see picture belew
MiNT information from APs leaked to WLC2 . I want kick them back to WLC1
MiNT infromation from APs on WLC2 (correct).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-19-2019 10:57 PM
Please review the switch side config for WLC ports (if native vlan is not tagged, proper native vlan/PVID should be set on the switch side as well) and for the APs meant to be used by those controllers. Or go to IP-based adoption for higher level of predictability if that might help.
Within a single VLAN maybe static adjustments of MINT Area-Id would help but that sounds like a hassle if it's possible to just separate the broadcast domains for one and another wireless mgmt/control plane.
Hope that helps,
Tomasz
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-14-2019 09:01 AM
Hi Kelly
Now I have some issues , RF Domain and some APs form WLC1 jump to WLC2
follow the picture the RED SQURE form WLC1
WLC1(RFS6000)firmware 5.8.4 VLAN :10 Uplink to switch config as trunk Native vlan 10
WLC2(NX5500)firmware 5.8.9 VLAN :11 Uplink to switch config as trunk Native vlan 11 allow 10
VLAN 10 use for WLC1 and switch management . T
Thanks in advance for any help that you are able to provide.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎09-10-2019 04:20 PM
