Hi all , I uploaded the APs firmware to my virtual controller . Butt APs can’t download firmware as a picture below. didn’t change MTU configuration. Thanks you.
Hi all I facing a issue APs not get configuration from profile I have AP7632 3 units I set one of AP7632 as Virtual Controller Virtual Controller status look well , All APs were online. APs adoption by MiNT L2 broadcast on VLAN90 Ther...
Hi all My WLC firmware is 8.4 AP model : 7502(ac) I got a big issue with iOS devices , When I speed test on iOS devices(Iphone 7,8,10) upload/download not over 10 mbps butt with Android speed around 70-80 mbps. Some of setting all of APs in t...
Hi all ,
My WLC is RFS-6000 firmware 8.4.0
All APs models adoption to WLC by VLAN and didn't any DHCP server.
Follow the pics AP650 primary IP is 0.0.0.0
Why APs didn't show default IP 169.254.x.x / 16 ( manufactory )
On AP status
O...
Hi all
I have problem about port configuration between WLC(NX5000) and core switch(Cisco catalyst)
vlan 11 for manage APs
vlan 10 for manage all device (swtich,WLC,server ,etc)
On WLC(NX5500) uplink port configure as
Trunk native vlan 11
No ...
It sure sounds like an MTU problem. Try lowering MTU to 1200 or lower to see if that makes a difference. Also make sure there is no firewall blocking UDP port 24576. Hi, How to change controller MTU size by GUI ? Thanks for advance.
Hi allFollow the picVlan 10 for manage all devices WLC1,switch,server,pc etc... WLC1(RFS6000)firmware 5.8.4 VLAN :10 Uplink to switch configured as trunk Native vlan 10WLC2(NX5500)firmware 5.8.9 VLAN :11 Uplink to switch configured as trunk Native...
Does the NX5500 have an IP address on VLAN-11?
Yes , There are 2 IP address , VLAN10 and VLAN11
Are there any ACLs between the APs and the NX5500 that would block UDP port 24576?
I didn't do anything on ALC.
You seem to be saying that the APs ...
