¿How to adapt an AP-7632i to a virtual controller?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-05-2019 04:02 PM
Currently, we find the need to know how to do so that an AP-7632 adapts the virtual controller solution.
If someone has information we would be very useful.
Since we must work with the virtual controller solution to put 16 ap where one is the one that supports VC.
If someone has information we would be very useful.
Since we must work with the virtual controller solution to put 16 ap where one is the one that supports VC.
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-05-2019 05:01 PM
Here is the same doc Christopher shared but its just published on our documentation site:
Heterogenuous VirtualController-QuickStartGuide
Heterogenuous VirtualController-QuickStartGuide
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-05-2019 04:31 PM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-05-2019 04:17 PM
Also this KB article maybe useful :
Unable to adopt heterogeneous (different) APs by my WiNG virtual controller
Unable to adopt heterogeneous (different) APs by my WiNG virtual controller
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
09-05-2019 04:05 PM
See THIS article.