I can't see the web interface of an AP510i in standalone mode

[jflores]

I have an AP510i in standalone mode but I can't see the web interface to configure it.
This is the IP that I am connecting to according to the manual.

I already have connectivity between the laptop and the AP.

But when I try to infest from any browser, it throws the following error.

Does anyone know if I have to enable a service in order to manage the web interface.

[jflores]

Thank you very much, update the firmware and you can manage it via the web.

[Christoph_S · Accepted solution]

Hello Jesus,

As Mig said, you probably have a LEAN image on your AP. You cannot differentiate between the 2 once installed. I would recommend you upgrade to the latest 7.3.1.4 firmware and not reinstall the same version. Make sure you select the full and not the LEAN version. 

Regards,

Chris

[Miguel-Angel_RO]

Jesus,

I do have the same behavior after full reset.

I had no web access before.

I cannot have it adopted on the Clouc but well on an XCC.

Mig

[Miguel-Angel_RO]

Jesus,

It seems that you have the standard image deployed.

Check here:

https://gtacknowledge.extremenetworks.com/articles/Q_A/What-is-purpose-of-files-within-WiNG-firmware...

I’ll check that on my own AP.

Mig