wing 4.x for RFS6000 series
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 09:42 AM
Good day!
I have a problem. It is necessary to connect the AP-5131-4006-wr access points to the RFS-6010-1000-wr controller. Wing 5.5 is installed on the controller. If I understand correctly, you need wing 4.x for the connection.
Question. Maybe someone has this version of wing?
I have a problem. It is necessary to connect the AP-5131-4006-wr access points to the RFS-6010-1000-wr controller. Wing 5.5 is installed on the controller. If I understand correctly, you need wing 4.x for the connection.
Question. Maybe someone has this version of wing?
11 REPLIES 11
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 12:43 PM
Feel free to contact me directly at +420731687227. AP5131 firmware should be included in zip
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 12:43 PM
Thank you so much misha! I have been search for this firmware for so long. The world is not without good people))
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 12:43 PM
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 12:43 PM
Currently, 10 ap-5131 work autonomously. A 6000 series controller was purchased for seamless roaming.
But as it turned out, WiNG 4 is very difficult to find.
But as it turned out, WiNG 4 is very difficult to find.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Get Direct Link
- Report Inappropriate Content
‎11-20-2018 12:43 PM
Igor, the 5131 is only a WiNG-4 AP. There are *no* versions of WiNG-5 that operate on a 5131.
If you already have a network in place using the RFS6000 with other WiNG-5 APs, and you want to also use the 5131's, you would either need to setup another controller using WiNG-4 so that it can mange the 5131's, or you can setup the 5131's to operate autonomously, without a controller.
If you already have a network in place using the RFS6000 with other WiNG-5 APs, and you want to also use the 5131's, you would either need to setup another controller using WiNG-4 so that it can mange the 5131's, or you can setup the 5131's to operate autonomously, without a controller.
