Network Architecture & Design - Page 39 - Extreme Networks

Network Architecture & Design

Questions and discussions about network architecture and design in general

Forum Posts

Sorted by:

Start a conversation

MLAG configuration between two Black Diamond

create mlag peer "CORE-A" configure mlag peer "CORE-A" ipaddress 199.199.199.1 vr VR-Default configure mlag peer "CORE-A" interval 1000 enable mlag port 10:47 peer "CORE-A" id 20 enable mlag port 10:48 peer "CORE-A" id 10 W...

UDLD like functionality in EOS?

Hi, what functionality in EOS can be used to detect unidirectional links, similar to UDLD in Cisco IOS? At a first glance I see the following possibilities: Loop Protect, which requires reception of BPDUs CFM BFD (for routed ports (emulated using...

How to dual uplink a single x440 G2 to two x670s G2's in MLAG with ISC Link

Hello, Fairly new to Extreme and coming over from Cisco so I'm hoping I have the terminologies correct. I have one x440 G2 that I want to uplink two ports from, to a pair of x670's in a MLAG with ISC Link between them. The 670's are already in pro...

Should the firmware upgrades be done on both partitions or just one; what is best practice?

I'm upgrading our Summit X460G2-48p-10G4's form v.16 to v.21. What is the best practice or convention when upgrading? Should both partitions be done or should one be left to revert back to in case a roll back is needed?

Bootp or UDP_profile , which has presidence when both configured.

I have just recently taken over a network , that has both bootp and UDP-profiles configured fro teh same vlans. I have used both individually , aka old days we could only specify single IP address for DHCP server in Bootp , and udp-profile for choosi...

Top Kudoed Authors

User

Count

4

3

3

3

GTM-P2G8KFN