How to add VX9000 to XMC wireless controllers tab

[Yoann]

Hello,

I set up XMC with all its components (netsight, analytics, fabricmgmr and NAC) running 8.2.5.50.
I also set up a cluster of VX9000 running 5.9.4.1-004R with one AP8533 (same version).

I would like to link the VX cluster and the AP to XMC but I could not find how.

The device discovery is OK, I can see both wireless controllers in the device tab (thanks to the ZTP+ configuration), but nothing appears in Wireless -> Controllers.

I enabled "Collect device statistics" on both controllers.

What configuration am I missing ?

Thanks

[Zdeněk_Pala]

you may check this:

https://extremeportal.force.com/ExtrArticleDetail?an=000096189

[Zdeněk_Pala]

the list of supported controllers for each version is published here: https://emc.extremenetworks.com/content/common/releasenotes/extended_firmware_support.htm
select version and wireless.

The Wireless Tab requires a supported controller. Please check with the local Extreme representative your options.

[SDR]

Hi Zdenek,

thank you. However I´m quite confused.
It´s even NOT possible, to get VX9000 into XIQ-SE (!!) Wireless Tab? 
Customer does not want cloud connection....

If it is possible (in XIQ-SE), pls advise how. I just tried by myself without success
If it is NOT possible (in XIQ-SE): What CAN be "connected" to XIQ-SE Wireles Tab?

😞

[Zdeněk_Pala]

AFAIK you can connect WiNG to XIQ. You can upgrade XMC to XIQ-SE and XIQ-SE can be connected to XIQ.
The XIQ can be your single pane of glass (single glass of pain).

Attached guide can help you regarding WiNG and ExtremeControl. I hope it helps.