Extreme Networks

HipG · 11-17-2022

Hi,In the Network OS Layer 3 Routing Configuration Guide, various versions, there is a section on the DHCP relay and supported configurations. It has the following diagram.......and the following description of supported and unsupported configuration...

HipG · 06-11-2020

Hi, Is someone able to confirm the behaviour I’m seeing is correct. I have a 2 switch VCS, with VRRP-E and short-path forwarding configured. Virtual fabric gateway is not configured. If I ssh to the VRRP virtual IP address I can land on either ...

HipG · 06-04-2020

Hi, Pretty new to VDX and I can’t find much documentation on it as far as configuration goes, but is ECMP supported on the VDX-6740 for static routes. For example if I configure 2 static routes to the same destination via 2 separate L3 direct connec...

HipG · 07-26-2021

Hi, I think I might be seeing the same issue as this, did you find a solution?Im adding a VDX6740 to a management tool and everything works with SNMP apart from the LLDP information. LLDP is working on the device as in your case. I haven’t tried snmp...

HipG · 06-04-2020

Thank you Michael, sorry I didn’t mean I couldn’t find much documentation in general, but I can’t seem to find the information I was after specifically. There seems to be a command to set the maximum number of ECMP paths, but exactly how it works or ...

HipG · 06-04-2020

Thank you Balaji, just to clarify, if its round robin it doesn’t use any other algorithm or hashing technique? Does this mean flows from/to same source and destination can go down different paths each time? Also does the round robin also come into ef...

Extreme Networks

User Statistics

User Activity

Brocade IP DHCP relay overview - supported configurations query

VRRP-E Virtual IP addresss and short-path forwarding

VDX-6740 ECMP Static route

Re: Unable to retrieve LLDP neighbour information via i.e. snmpwalk (show lldp neighbour works)

Re: VDX-6740 ECMP Static route

Re: VDX-6740 ECMP Static route