Extreme Networks

Is there a way in EMC Extreme Management Center 8.3.3.11 to schedule a maintenance window automatically perhaps using Remove from Service option in Device Configuration?

Extreme Management Center   8.2.6.5 According to the information below from knowledgebase article, there is a report of all devices that have  been removed from service. I’ve scoured the reports section of EMC and cannot find it. Where might this rep...

Is there a way to throttle alarms coming from a WING controller? I see an option "time to aggregate repeated messages" but the time option is for 1 minute maximum. I have some alarms set to go email but in some situations it's possible that the con...

One of my rfs6000 wing controllers is logging this alert every two minutes: Jun 07 14:39:48 2019: wls-dc07-1 : %CLUSTER-4-STATE_RETAIN_ACTIVE: Member 19.F9.60.CB (load50) retaining Active state. New member 19.F9.5C.43 standby load 8. Here are clust...

I've enabled WIPS on several APs & their controller. I enabled all alerts available in the WIPS policy I created. I'm receiving many "excessive scanning" alerts from numerous devices but I can't find any information about this situation. What is "ex...