Extreme Networks

Rahman_Duran · 10-16-2019

Hi, We have a point to point metro ethernet networks of 200 mbits up/down. When the traffic hits 200 mbits, ISP drops packets. We want to apply QoS and Rate limiting/shaping so we won’t let ISP to trothle the link. We have several AP’s running on the...

Rahman_Duran · 09-19-2019

Hi, I want to permit selected subnets and deny all other subnets ingress traffic to our PBX vlan. I configured ACLs shown below. But I can still access to PBX VLAN (web pages of IP phones on PBX VLAN) from every where. What shoul be the problem? PB...

Rahman_Duran · 09-11-2019

Hi, I am trying to load configuration template to a ZTP discovered SecureStack A4H124-24 switch. I choose the config tampate, I choose firmware update version and hit start button but I get an immediate error on invertory logs: "No device informatio...

Rahman_Duran · 07-26-2019

Hi, This is not a question post. I just want to say "thank you" to whom responsible for this feature. Now I can only use XMC to monitor all our gears where I only need to see if they are up and down, without any additional licensing cost. No need to...

Rahman_Duran · 07-25-2019

Hi, I can't open Extreme Management Center 8.3.0.111 Release Notes pdf file from ExtremePortal. It seems it is corrupted. Is there any alternative location for release notes? Regards, Rahman

Rahman_Duran · 03-09-2020

Hi, I know they are different tools but can I do what I am trying to do with Policy instead of ACLs? Can “Policy” resctrict which IP subnets access to a whole VLAN? “Short answer is: You will not create ACLs with Policy Manager in XMC 8.4 and o...

Rahman_Duran · 03-05-2020

Hi, Can we also use XMC Policy Manager without NAC, for L3 ACLs? I am configuring ACLs by CLI and appling them to a VLAN interface on S series and C5. I also do it on X460-G2. So is it possible with Policy Manager? If it is possible I want to use ...

Rahman_Duran · 01-08-2020

Which key combo are you using? I can copy&paste with CTRL+INS and SHIFT+INS without any problem.

Rahman_Duran · 11-27-2019

Hi, Just want to give feedback, GTAC confirmed this as a bug and it will be solved with an update later. Regards, Rahman

Rahman_Duran · 11-27-2019

Hi, You should tag VLANs on both ends (X440 and 220). Just share configurations of X440 and 220 so we can help better. Regards, Rahman

Extreme Networks

User Statistics

User Activity

Applying to QoS to Wireless controller "control" traffic.

EXOS dynamic ACL on VLAN not working.

SecureStack ZTP provisioning

XMC device poll type, status only :)

Extreme Management Center 8.3.0.111 Release Notes corrupted?

Re: Policy Manager XMC

Re: Policy Manager XMC

Re: 8.3 Webshell Copy and Paste not working

Re: SecureStack ZTP provisioning

Re: X440 Core Switch