Hello everyone,since Analytics Release 8.5.3 the Extreme Analytics Engine combines the sensor and the engine:“Extreme Networks is introducing the new Extreme Application Sensor and Analytics Engine. This new Analytics engine combines the sensor and e...
Hello, everyone, I have an X465 as CB and a V400 as BE. Everything works fine, only in the XMC there is no link between the two devices. Additionally the status is defined as "Unknown". Is there any trick to actively trigger the link conn...
hi everyone,
i am currently testing the integration of exos switches in Solarwinds software (IPAM/UDT).
In order to correctly assign MAC addresses to IP addresses, the following OIDs are required:
ipNetToMediaTable = 1.3.6.1.2.1.4.22
ipNetToPhysical...
Hi peter, you can use acl‘s to deny intervlan traffic inside an VR. Check this knowledge article: https://gtacknowledge.extremenetworks.com/pkb_mobile#/articles/en_US/How_To/How-to-use-an-ACL-to-prevent-inter-VLAN-traffic-for-internal-subnets-but-all...
hi gobrien, all you need to do is to enable mac-locking, enable mac-locking violation trap/log and create an alarm inside xmc. For exampe with port 1: enable mac-locking enable mac-locking ports 1 configure mac-locking port 1 first-arrival limit-...
Should be fixed in XMC/Analytics Version 8.2.4.55:
"Adding an ExtremeXOS device to ExtremeAnalytics as an Application Telemetry Source was not supported when the host IP was applied to an engine other than the VR-Default."
