Extreme Networks

Pionio · 02-02-2024

HelloWe manage switches from a configured NAC in XMC. We need to change the IP address of some switchs and we realize that changing data in the configuration switch it's not seen in console management as expected.We haven't found an option in XMC for...

Pionio · 09-22-2020

HelloFirst of all, my apologies if this question has been solved before.When we test adding a new node to X440G2 stack I realize that the new ports added are no configured properly based on our custom configuration.Is there any way to extend the sett...

Pionio · 05-03-2019

Hello Nine month ago I asked for help related to Dynamic Vlans and STP. https://community.extremenetworks.com/extremeswitching-exos-223284/dynamic-vlans-and-stp-7761542 Stephen Williams warned us that STP does not support dynamically created VLANs...

Pionio · 08-27-2018

Hello I want to mac authenticate C5 with X450. In X450 I enabled netlogin mac auth and tested with other X450 but when a connect C5 link is up and nothing happens. RADIUS are not triggered. Do I need make any configuration in C5? Thanks in advanc...

Pionio · 08-22-2018

Hello We want to replace a Smart Switch 6000 that has attached a C2G124-48 through port 24. Both switches has VLAN created statically. The new switch is a X450-G2 and VLAN are created dynamically using MAC auth and RADIUS. When we connect a PC or o...

Pionio · 10-13-2021

HelloAny news to solve this issue?Thanks in advance

Pionio · 09-22-2020

Hello Stefan Custom configuration ports: configure port 1:1 rate-limit flood broadcast 200configure port 1:1 rate-limit flood multicast 200...enable netlogin ports 1:1-46 macconfigure netlogin ports 1:1 mode mac-based-vlans…If I add a new node stack,...

Pionio · 09-05-2018

Hello Dynamic VLANs aren't working in a mixed architecture with old Enterasys and new Extreme devices. An approach to solve this is using a VSA (211) to create VLANs with MAC auth for every switch. Without Dynamic VLAN is necessary to create stati...

Pionio · 08-29-2018

Hello Authenticating C5 through MAC via Netlogin works perfect. The reason I did'nt find any info in log messages was C5 acts as a passive device and doesn't send any info to port switch connected. When a device is connected to it or I execute pin...

Pionio · 08-28-2018

Hello Netlogin configuration is exactly the same as the link you shared and works perfect for all devices connected (C5 not). I'm sure BPDU is not part of this issue. I tested BPDU executing command: configure stpd ports link-type edge edge-safe...

Extreme Networks

User Statistics

User Activity

Change IP switch managed by NAC in XMC

Adding a new node to stack do not replicate configuration ports to new ports added

STP and MVRP auto binding

MAC Authenticate Enterasys C5 in Extreme X450

Connect switch to X450-G2 with dynamic VLAN configuration

Re: STP and MVRP auto binding

Re: Adding a new node to stack do not replicate configuration ports to new ports added

RE: Connect switch to X450-G2 with dynamic VLAN configuration

RE: MAC Authenticate Enterasys C5 in Extreme X450

RE: MAC Authenticate Enterasys C5 in Extreme X450