I am trying to install the new version of EMC version 8.0.4 at the recommendation of the manufacturer, but it has not been possible because of any of the ways I try with OVA, ISO or other does not work the installation and gives the error attached in...
As I can have through snmpv3 all the statistics of CPU, memory plus all the data of the statistics of the interfaces that are monitored.
I also need to fine tune all the EMC features for other vendor in this case I require on CISCO.
Thank you for y...
How can I in Netsight through the events of Syslog or Traps bring me the following data of the switch or Access Point?
SysName:
SysLocation:
SysContact:
System MAC:
System Type:
SysHealth check:
Recovery Mode:
System Watchdog:
Current Time:
Timezone...
I need to change the port of the SMTP service in NetSight for sending mails through Office365 as it does through port 587
I appreciate your collaboration.
I have a Netsight lab running fine with my virtual appliance, installing the purview virtual appliance, setting up the sensor over netsight, but I do not get statistics.
In the purview configure the interfaces of mode 2 ie eth0 for managemen...
Hi Bharathiraja
I have some devices of differents vendor: Cisco Catalys, Cisco Nexus, Extreme, Avaya.
View Cisco Device
View Avaya Device
This is the configuration snmpv2 to Cisco "snmp-server group BCNOC v3 priv
snmp-server user snmpc0rr3v4l BC...
I have a concern, you can share what configuration of snmp and syslog applied on Cisco computers both Switches, Router and Controllers and Access Point on EMC.
I would also like to know if I can register any controller in EMC and be able to have con...
Hello Daniel,
I saw in Hub Extreme Networks that have done well with NetSight and for that I would like to be able to learn from their experience in the implementation of monitoring of equipment and brands like Cisco.
The truth is that it used 99% o...
