Aerohive Migrated Content - Page 442 - Extreme Networks

Aerohive Migrated Content

Questions and discussions related to old aerohive products migrated over

Forum Posts

Sorted by:

Start a conversation

SR2208P does not appear to have host resources stats available via SNMP?

I am attempting to poll SNMP for Host Resources on SR2208P and am getting no where. These switches seem to be pretty limited in terms of what is available via SNMP. Am I missing something?

Resolved! Wifi Channel / Wifi Power showing DOWN on both radios

Regardless of profile change and/or manual setting of the radio channel and power, the state of both radios remains DOWN. The AP is successfully connected to the Hivemanager and I am able to send reset commands to the AP through the portal...Does an...

How do I remove an interface from an aggregation port on a 2300 switch via CLI?

I have attempted to push a config change via HM to remove two ports from an aggregation port. Here is the current config... interface 1/0/20classofservice trust ip-dscpdescription 'trunked vlans'switchport mode trunkswitchport trunk allowed vlan 1,5a...

Hello, In a PPSK authentication Wireless network, is that possible to setup the limit of the maximum number of clients per PPSK regarding the group ? For example user-groupA can connect 5 user-groupB can connect only 1 Thanks for your help

Hello, In a PPSK authentication Wireless network, is that possible to setup the limit of the maximum number of clients per PPSK regarding the group ? For example user-groupA can connect 5 user-groupB can connect only 1 Thanks for your help

Resolved! Unable to perform uploads

Hello,I'm unable to perform uploads on a AP130 access point.In the CLI I have the following error: capwap: system: "scpuser" failed to scp x.x.x.x server. rc=5(0) I've reset the AP already, but the error is present still.Kind regards

Top Kudoed Authors

User

Count

4

3

3

3

2

GTM-P2G8KFN