01-03-2019 09:25 PM
We have the ap 250 and you can use 2 network cables 1 on eth0 and 1 on eth1 we like to bond them so that they use 1 IP-adres does someone know how?
thank you in advance
07-09-2019 07:51 PM
You'd want to configure trunk ports if you've got more than one VLAN going through.
07-09-2019 07:18 PM
When you connect these ports to a 2-port etherchannel on the switch (trunk ports) what port type do you specify on the ap250? Uplink or trunk?
01-03-2019 09:53 PM
Okay Thank you for your answer I’ll look into it tomorrow.
01-03-2019 09:47 PM
It's almost physically impossible for the AP to exceed the 1gig Ethernet line max, so aggregating the ports doesn't have a lot of practical value. However, to do this, you would want to go in to Configure> Open the network policy> Go to Device Templates tab> Open the device template in use or create a new one> Select both Eth ports and Click Assign> Advanced Actions> Aggregate. You should now see an aggregate port in the "Wired Interfaces" section at the bottom of the template.